MIL-B-16028G
This type is intended for rehandling and
6.1.4 Type IV, ore rehandling.
stockpiling ore.
6.1.5 Part or Identifying numb ers (PIN). The PINs were developed to
identify items covered by this specification for cataloging purposes. The PIN
consist of this specification identifier (M16028), the type and size as
determined by classification section 1 and type and size as per table I.
TABLE II. Bucket Type and Size.
6.2 Acquisition requirements. Acquisition documents should specify the
following:
a.
Title, number, and date of this specification.
Type and size of bucket required (see 1.2 and 1.2.2).
b.
Issue of DODISS to be cited in the solicitation, and if required,
c.
the specific issue of individual documents referenced (see 2.1.1
and 2.2).
d.
When first article is required for inspection and approval (see
3.2, 4.2.1 and 6.3).
When teeth, points, shanks, keepers, and keeper locks shall conform
e.
to M1L-T-52176 (see 3.6.3).
f.
When type I bucket with teeth is required (saee 3.6.3).
g.
When side and corner teeth are required (see 3.6.3).
h.
When sheave bearings other than specified are required (see 3.6.8).
i.
When sheave groove cleaners are required (see 3.6.8).
j.
When cleaning, treatment and painting in accordance with
10
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business